HB636 Sliding Door Lock - 250mm

Halliday + Baillie Sliding Door Lock Set with no furniture on outside of the door, and integrated end pull. The HB636 has the same configuration as the HB633 but with an additional finger end pull for pulling the door out of a cavity or pocket. Ideal for use where no access or flush pull are required from outside. Has key and snib flush pull on the inside of the door, and end pull in edge of door lock. Cylinders to be ordered separately with confirmation of the door thickness.

Material: Diecast zinc with brass and 316 stainless steel

Backset : 55mm

Minimum door thickness : 38mm

Flush pulls : 250mm x 36mm x 13mm

Suitable for timber or aluminium doors

For finish options please see our current Finishes Sheet. Please check with your local Halliday + Baillie representative as not all finishes are available in all regions.

Glue, epoxy, silicone products etc are not required or recommended for installation, and may void warrantee.

Configurations:
HB 638 – Key and Snib Both Sides
HB 637 – Key Snib In, Blank Out
HB 636 – Key Snib In, No Pull Out

Product code: HB 636

Please click here for the HB638 Series data sheet:AA HB638.pdf
For installation in timber doors, please click here for the HB604 Timber Fixing Kit data sheet:A HB604.pdf
Please click here for the Halliday + Baillie Finishes Sheet:AA HBFinishes All.pdf