%label%
%sku%%description%
- / Product overview
HB636 Sliding Door Lock – 55mm Backset with Integrated End Pull
The HB636 sliding door lock has an integrated end pull and is ideal for pocketed cavity sliders where locking and an end pull are required.
Halliday + Baillie Sliding Door Lock Set with no furniture on outside of the door, and integrated end pull. The HB636 has the same configuration as the HB633 but with an additional finger end pull for pulling the door out of a cavity or pocket. Ideal for use where no access is required from outside. Has key and snib flush pull on the inside of the door, and end pull in edge of door lock. Cylinders can be ordered separately with confirmation of the door thickness.
Material: Diecast zinc with brass and 316 stainless steel
Backset : 55mm
Minimum door thickness : 38mm
Flush pulls : 250mm x 36mm x 13mm
Suitable for timber or aluminium doors with wide stiles.
For finish options please see our current Finishes Sheet. Please check with your local Halliday + Baillie representative as not all finishes are available in all regions.
Flush pulls are designed to be mounted with the body within the thickness of the door, and the face plate on the door surface – total projection is 2mm. Fully recessed mounting is possible on timber doors with the appropriate door thickness. Using glue, epoxy or silicone products etc to secure flush pulls to the door is not required or recommended for installation, and may void warrantee. Glue, epoxy, or silicone products can be used to secure the spindle bar to the back of the snib flush pull for example where sets have a flush pull to one side only.
.
Configurations:
HB 638 – Key and Snib Both Sides
HB 637 – Key Snib In, Blank Out
HB 636 – Key Snib In, No Pull Out
- / Product downloads
Resources
Technical downloads
- / Related products